Using remote controller
Controlling an Integra/Onkyo DVD player
The connector of the Integra/Onkyo DVD player must be
connected to the DTR-6.3/5.3 (see page 29).
1. Press the DVD Mode button.
The DVD Mode button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Integra/Onkyo DVD
player.
Operation buttons:
On: Turns DVD player on and off
Standby: Turns DVD player off (Some sets may not respond to this
button. In this case, use the On button to put the DVD player in the
standby state.)
OnStandby
Setup: Displays OSD Menu of the DVD player
DVD Mode: Moves cursor in the OSD Menu of the DVD player
ENTER: Enter button for the OSD Menu of the DVD player
Return
SetupReturn: Return button for the OSD Menu of the DVD player
ENTER,
Top Menu or Menu: Displays menu screens recorded on DVD
DISCVOLmedia
Disc : Selects disc in DVD changer
Top MenuMenu
Audio SELMutingAudio SEL: Selects audio or language track (if recorded on the
DVD)
AngleSubtitle
Angle: Selects camera angle (if recorded on the DVD)
DVD
operationSubtitle: Selects subtitle language (if recorded on the DVD)
buttons
Search: Searches for location on disc to start playback
Random: Random playback
: Chapter/Track down
: Chapter/Track up
Numeric keys
: Play
: Stop
Search
: Fast reverse
: Fast forward
: Pause
: Opens/closes disc tray
0, 1 to 9, +10: Numeric keys
You may also use the following buttons:
VOL : Adjusts volume at DTR-6.3/5.3
Muting: Activates muting function at DTR-6.3/5.3
Note:
When operating an Integra/Onkyo DVD player directly with the
remote controller without connecting the terminals, pre-
programming is necessary (see page 66).
64 |